Worktop for 2 Modules


Worktop module, to be applied above 2 DEA modules (90 or 110 series).

The worktop is made of 0.07 inches (2 mm) thick sheet metal folded four times, welded in the corners for additional reinforcement and of 2 omega bars along the entire length of the module. The bars can also be used to pass piping and power cables.

The worktop is covered in scratch-proof DTC to make it resistant to scratches, mineral oils, fuels, acids, etc.

All the components are epoxy powder coated.

Furthermore, there are pre-cuts in the shorter sides that can be easily opened during the installation phase in order to feed in oil pipes, electrical cables, water and air hoses, etc.

Configurations in which this product is found
installed in
  • Auto Repair Shops (mechanical, diagnostics, tyre/wheel alignment, pre-delivery, receiving, engines and transmission areas)
  • Motorcycle Repair Shops
  • Body Shops (pulling, dismantling, pre-delivery, receiving areas)
  • Workshops
  • Industrial Facilities
Photo and video gallery