Worktop for 1 Module
Worktop to be applied above 1 DEA module (90 or 110 series).
It has an inward-outward opening on the upper part to garantee direct access to the below mounted module.
The worktop is made of 0,07 inches (2 mm) thick sheet metal folded four times, welded in the corners for additional reinforcement and of 2 omega bars along the entire length of the module. The bars can also be used to pass piping and power cables.
The worktop is covered in scratch-proof ABS/DCT to make it resistant to scratches, mineral oils, fuels, acids, etc.
All the components are polyester powder coated.
Furthermore, there are pre-cuts in the shorter sides that can be easily opened during the installation phase in order to feed in oil pipes, electrical cables, water and air hoses, etc.