Worktop for 1 Module
Worktop to be applied above 1 DEA module (90 or 110 series).
It has an inward-outward opening on the upper part to garantee direct access to the below mounted module.
The worktop is made of 2 mm thick sheet metal folded four times, of welded in the corners for additional reinforcement and of 2 omega bars along the entire length of the module. The bars can also be used to pass piping and power cables.
The worktop is covered in scratch-proof DTC to make it resistant to scratches, mineral oils, fuels, acids, etc.
All the components are epoxy powder coated.
Furthermore, there are pre-cuts in the shorter sides that can be easily opened during the installation phase in order to feed in oil pipes, electrical cables, water and air hoses, etc.